Radxa Zero 3W with APPFV OpenIPC v0.0.1
This is a pre-built image for the Radxa Zero 3W that lets you stream OpenIPC video using the APPFV firmware.
Warning!
You need to connect a 2.4GHz or 5.8GHz antenna to the UFL port on the Radxa board!
This firmware uses the built-in AIC8800 Wi-Fi module on the Radxa Zero 3W board and automatically connects to APPFV OpenIPC.
The image is pre-configured to connect to the APPFV firmware's wireless network using the default credentials.
Setup guide
Step 1. Download the .xz file and unpack it. Write the resulting .img image to a microSD card.
Step 2. After writing, put the card back into the computer — the /config partition will be mounted. Open the setup.txt file in a text editor and edit it:
Resolution and frame rate:
Specify the formatWxH@fps, for example:1920x1080@60,1280x720@120
Choose either the maximum supported resolution or frame rate.DVR fps:
rec_fps=60Set the DVR frame rate to match the camera: 60, 90, 120, etc.
GPIO layout:
layout=RubyAccepted values:
Ruby,Bonnet,Runcam,CustomThe pinout file is in
/config/scripts/gpio/custom.yamlFor a ground station with MSPOSD:
osd=ground
Step 3. Connect the antenna (2.4GHz or 5.8GHz), insert the microSD into the Radxa and power it on. If all settings are correct, the openipc firmware will start and automatically connect to your camera.
Notes for version 0.0.1
- This is the first release. USB Wi-Fi drivers are included but not yet activated.
- All settings are made in a single
setup.txtfile in/config/. - For CLI access: temporarily delete or rename
setup.txt. - The GPIO has 2 functions:
- short press — start/stop DVR recording
- long press (3+ sec) — enable AP Mode
- AP Mode:
SSID:OpenIPC GS
Password:openipcgs
Accessing the DVR
- Via the SD card:
Insert the card into a PC — the/dvrpartition will be mounted - In AP mode:
Go tohttp://radxa-zero3.localin your browser - Through the home network (Samba):
Connect with login/password:root/rootorradxa/radxa